Subject: From: Date:

Re: [ECS] Re: Help with training SDK v 4 Mark Gilmore Tue, 19 Jan 1999 17:15:33 -0800

---

GOOD JOB BILL !
Guess I need to document this, huh :-)

Bill Walters wrote:
> 
> Yes, I have SDK 4.0 installed.
> 
> To "Train" your VR engine (from what I can figure) without messing with
> ECS, do the following.
> 
> Start | Programs | Microsoft Voice
> 
> That will take you through a series of prompts about your
> speakers/microphone.  Complete those.
> 
> When you're done, you'll see a small icon in the system tray (lower
> right hand corner of screen) with a green circle and the letter "V"
> inside it.  RIGHT click on that, and you'll have access to training MS
> Voice, just like the note from Oliver Hirschberg says, which you
> attached to the note I replied to...
> 
> Basically, I guess the "Key" here is that you'll train the VR engine
> OUTSIDE of ECS.
> 
> Hope this helps.
> 
> Bill Walters

-- 
Mark Gilmore
Omnipotence (ECS Home Automation Software)
Voice:423-745-0026
FAX  :423-745-1714
omnip@usit.net
http://www.usit.com/omnip

---