Subject: From: Date:

Re: [ECS] ADPCM and CID question Mark Gilmore Tue, 19 Jan 1999 17:26:32 -0800

---

Greg, I need to know that you are doing to trigger
this error.

Greg Johnson wrote:
> 
> Hi,
> 
>  I'm getting the following errors:
> "PM:Unsupported rate for ADPCM compression (8000HZ)"
> I checked the ADPCM settings in the control panel and they are set to "all
> rates".  I'm using a Ensoniq sound card which hasn't had any troubles in
> the past. Is this a win98 or ECS setting?
> 
> I also have a cheap BTC 56IP modem which i was using for caller id in the
> past. It has the Rockwell chipset and does respond ok to the "AT#CID=1"
> command. When I get a new call it detects the number of rings fine, but
> the caller id info never seems to make it. The modem will call out and
> record so it seems like it is recognized by the system ok. Any ideas?
> 
> Phn_c.set file:
> |ATZ                    // reset
> ?|AT$$H8&W              // disable HOT-SCAN feature
> |ATX4                   // send ALL responses
> |AT#CID=1               // enable caller-id
> |AT#CLS=8               // enter voice mode (for DTMFs, etc)
> |AT#VTD=FF,FF,FF        // ena ALL DTMFs, ALL modes
> |AT#VRA=60              // remote phone "answered" if no ring after 6 secs
> |AT#VRN=60              // remote phone "answered" if no ring after 6 secs
> |AT#VBT=1               // .1 sec beeps
> ?ATS30=60               // assure recovery if DTE dies (???)
> |AT#VSP=50              // silence tmo = 5 secs ???
> |AT#VLS=4               // line-input, spkr & line/handset ena
> 
> Thanks,
> Gregory Johnson
> diggins@teleport.com

-- 
Mark Gilmore
Omnipotence (ECS Home Automation Software)
Voice:423-745-0026
FAX  :423-745-1714
omnip@usit.net
http://www.usit.com/omnip

---