Subject: From: Date:

Re: [ECS] ir master 100 Dan Carrington Wed, 20 Jan 1999 08:53:46 -0800

---

Reading directly from the page sent with my Dancraft unit:

IR Remote Interface:
1 Blu  IR Output #1
2 Yel  IR Receiver Input
3 Grn  +9 VDC@100mA Accessory power
4 Red  IR Output #2
5 Blk  Ground (IR Return)
6 Wht  IR Output #3

RJ-11 Note: #1 is defined as the top pin when looking thru the connector
lock tab with cable on the left and connector on the right

Note: Each output channel may connect to 1 or 2 series LEDs, EM1, or
Video Link's Emitter #282-00.

Note: A 1k ohm load resistor must re connected across the Receiver Input
when using Video Link's remote receiver, DinkyLink Model #480  (I looked
up at what I had typed and found KinkyLink.  What a difference hitting
the wrong hand's finger can make!!!)

Dancraft also sells this exact breakout box called the B01 for about
$50.  (800)860-8910


Dan Carrington
(not of Dancraft)



paul venables wrote:
> 
> I would like to make a break-out box for the Ir. master 100,I believe that
> there are three
> extra emitters this way
> what I would like to know is the pin outs I remember awhile back some others
> did this.
> for the rj11  there are six pins.
> thanks in advance
> Paul

---