Subject: From: Date:

HV signals Mark Gilmore Mon, 25 Jan 1999 18:43:21 -0800

---

OK, HV/IR CODE BE GOOD (shouldn't have doubted myself :-)):
This is the just-enhanced doc on HV signals (note the asterics):
     1) Remote Monitoring
	----------------------------------------------------------------
	When you push an IR-button, the resulting signal is received by
	the HomeVision, which sends that signal's ID# to ECS. This Item's
	State then becomes that ID# for one Event pass (or UNKNOWN if
	the signal is not recognized), and is then reset to IDLE (unless
*	another signal is received). NOTE: For ECS to recognize a signal,
*	it must have an ID#, and so must be entered in the INFRARED
*	REMOTE CONTROL SIGNALS menu of the HomeVision software.
	One application is the use of an IR-remote as a Keypad.
-- 
Mark Gilmore
Omnipotence (ECS Home Automation Software)
omnip@usit.net
http://www.usit.com/omnip

---