Subject: From: Date:

Re: [ECS] Ping! Reddy Biggs Sat, 18 Jul 1998 12:22:22 -0500

---

Wayne,

I've got an RC-80 that I'm about to install in a new addition. The
instructions are quite vague, but it looks like I can send and receive
RS-232 with the 4 pin connector inside it.  I am planning on using ECS to
mostly send it commands, rather than try any receiving from it. Thus I can
program ECS to ramp up the heat at 6am on MWF only and setback at 9am . I'm
about 2 - 3 months from installation, so if you get to it first, let me know
how you did it, otherwise I'll send the list my programming.

Reddy




Our spam filters are on!  When replying, remove the "no-spam-to-" from our
address.
Thanks !!!


-----Original Message-----
From: Wayne Wittenberg <waynew@magicnet.net>
To: ecs-list@vancouver.ml.org <ecs-list@vancouver.ml.org>
Date: Saturday, July 18, 1998 12:02 PM
Subject: Re: [ECS] Ping!


>At 11:32 AM 7/18/98 -0400, Michael wrote:
>>Haven't received a message since the 15th.  Don't you guys have anything
to
>>say?  :)
>
>  Okay, I'll start!  I just received the HAI RC-100 thermostat that I won
at
>Jeff's Home Automator Mag. booth at the show back in January.  Is anybody
>using this with ECS?
>  I haven't had time to read the full docs yet, so I am not sure about how
>to do the serial I/F.  I know it can do simple contact closure for simple
>setback.
>
>c'ya,
>Wayne
>
>   waynew 'at' magicnet 'dot' net,   Orlando, FL
>   http://www.magicnet.net/~waynew
>
>

---