Subject: From: Date:

RE: [ECS] ECS and Type:Phone Answer gbailey Thu, 4 Feb 1999 21:03:11 -0700

---

This won't help you unless you have a VIVE caller ID unit, but if you do,
this will tell you if the line is in use or not in use:
I use a Phone Blaster board on one of the PBX ports and so don't have
visibility of main line activity. The Vive unit is placed on the CO side of
the PBX to monitor incoming line. The line sensor in the VIVE is accessible
via the UART registers as follows:

(Note that the port address is the com port base address plus 6 (in this
case base 340hex).)

|Item:Port_VIVE status          Type:I/O-Port-Byte
Acc:Owner/Maint
|	Initial State:0                                         Backup:No
|	Port Address :838

|       If      Port_VIVE status        Is GE           128
|       Then    Flag_phone in use       Set             Off
|       Else    Flag_phone in use       Set             On
|       End

\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
Garnet Bailey
gbailey@attcanada.net       ICQ# 23436806
/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\


-----Original Message-----
From:	Mark Gilmore [mailto:omnip@usit.net]
Sent:	Thursday, February 04, 1999 9:14 AM
To:	ecs-list@netbloc.com
Subject:	Re: [ECS] ECS and Type:Phone Answer

Sorry Bill, CALLER-HUNG-UP is supported only
with the BigMouth. This will be documented in
the next ECS.HTM.

Bill Walters wrote:
>
> Mark,
>
> I'm working with my phone event and having trouble getting my
> "ring-kill" relay to reset.  I had used (ECSD 3.4) the following
> statement:
>
> If      Phone-Answer    Is Now  Caller-Hung-Up
> Then    Ring Kill       Set     High
>
> However, it doesn't seem to work.
>
> Does "Phone-Answer" have a valid state of "Caller-Hung-Up" when using
> Phone-Interface-C?
>
> Thanks -
> Bill Walters

--
Mark Gilmore
Omnipotence (ECS Home Automation Software)
omnip@usit.net
http://www.usit.com/omnip

---