Subject: From: Date:

RE: [ECS] Reset interfaces remotely Mark Sekelsky Sat, 27 Feb 1999 16:31:11 -0600

---

At this point I am going to stop worrying about the JunkMaster (I can still
send you ecs.dt if you want it). I found that this time I couldn't get the
interface to reset at all, even after a complete shut down and reboot.  I
had ordered a Home Vision while my wife wasn't looking and now have it fully
up and running my IR, with PLC coming right behind it.

Mark S

-----Original Message-----
From: Mark Gilmore [mailto:omnip@usit.net]
Sent: Saturday, February 27, 1999 5:40 PM
To: ecs-list@netbloc.com
Subject: Re: [ECS] Reset interfaces remotely


You can set the Item to RESET, but it won't help
if a power-down on the IR-master is required.
This should be reproducable without ACE.
Try mimicking the same behavior with an Event.
What is your "signal delay" parameter ?
Please email me your ECS.DT.

Mark Sekelsky wrote:
>
> Mark,
>
> In using ACE with the IR Master I find that it is pretty easy to create a
> "not responding error."  I don't beleive this has anything to do with ECS.
> To correct this I need to unplug the IR Master and then go to the item
> editor and click on the "reset" button.
>
> I have tried to reset the IR remotely by resetting it via an event. (ex.
If
> reset is now true then IR Master set reset).  This isn't working.  Is
there
> a way to reset the interface without going to my ECS PC?
>
> Mark S

--
Mark Gilmore
Omnipotence (ECS Home Automation Software)
omnip@usit.net
http://www.usit.com/omnip

---