Subject: From: Date:

Re: [ECS] Reset interfaces remotely Don Sat, 27 Feb 1999 19:59:53 -0800

---

Atta Way, Mark!

----- Original Message -----
From: Mark Sekelsky <Mark@sekelsky.com>
To: <ecs-list@netbloc.com>
Sent: Saturday, February 27, 1999 2:31 PM
Subject: RE: [ECS] Reset interfaces remotely


>At this point I am going to stop worrying about the JunkMaster (I can still
>send you ecs.dt if you want it). I found that this time I couldn't get the
>interface to reset at all, even after a complete shut down and reboot.  I
>had ordered a Home Vision while my wife wasn't looking and now have it
fully
>up and running my IR, with PLC coming right behind it.
>
>Mark S
>
>-----Original Message-----
>From: Mark Gilmore [mailto:omnip@usit.net]
>Sent: Saturday, February 27, 1999 5:40 PM
>To: ecs-list@netbloc.com
>Subject: Re: [ECS] Reset interfaces remotely
>
>
>You can set the Item to RESET, but it won't help
>if a power-down on the IR-master is required.
>This should be reproducable without ACE.
>Try mimicking the same behavior with an Event.
>What is your "signal delay" parameter ?
>Please email me your ECS.DT.
>
>Mark Sekelsky wrote:
>>
>> Mark,
>>
>> In using ACE with the IR Master I find that it is pretty easy to create a
>> "not responding error."  I don't beleive this has anything to do with
ECS.
>> To correct this I need to unplug the IR Master and then go to the item
>> editor and click on the "reset" button.
>>
>> I have tried to reset the IR remotely by resetting it via an event. (ex.
>If
>> reset is now true then IR Master set reset).  This isn't working.  Is
>there
>> a way to reset the interface without going to my ECS PC?
>>
>> Mark S
>
>--
>Mark Gilmore
>Omnipotence (ECS Home Automation Software)
>omnip@usit.net
>http://www.usit.com/omnip
>

---