Subject: From: Date:

Re: [ECS] Reset interfaces remotely Mark Gilmore Sun, 28 Feb 1999 07:47:47 -0800

---

FYI:The reason I wanted to pursue this further is that MY
IR-Master behaves flawlessly (and has for years now).
I would ask that any that have had such problems email
me your model # (on the unit) and your ECS.DT. Thanks.

Don wrote:
> 
> Atta Way, Mark!
> 
> ----- Original Message -----
> From: Mark Sekelsky <Mark@sekelsky.com>
> To: <ecs-list@netbloc.com>
> Sent: Saturday, February 27, 1999 2:31 PM
> Subject: RE: [ECS] Reset interfaces remotely
> 
> >At this point I am going to stop worrying about the JunkMaster (I can still
> >send you ecs.dt if you want it). I found that this time I couldn't get the
> >interface to reset at all, even after a complete shut down and reboot.  I
> >had ordered a Home Vision while my wife wasn't looking and now have it
> fully
> >up and running my IR, with PLC coming right behind it.
> >
> >Mark S
> >
> >-----Original Message-----
> >From: Mark Gilmore [mailto:omnip@usit.net]
> >Sent: Saturday, February 27, 1999 5:40 PM
> >To: ecs-list@netbloc.com
> >Subject: Re: [ECS] Reset interfaces remotely
> >
> >
> >You can set the Item to RESET, but it won't help
> >if a power-down on the IR-master is required.
> >This should be reproducable without ACE.
> >Try mimicking the same behavior with an Event.
> >What is your "signal delay" parameter ?
> >Please email me your ECS.DT.
> >
> >Mark Sekelsky wrote:
> >>
> >> Mark,
> >>
> >> In using ACE with the IR Master I find that it is pretty easy to create a
> >> "not responding error."  I don't beleive this has anything to do with
> ECS.
> >> To correct this I need to unplug the IR Master and then go to the item
> >> editor and click on the "reset" button.
> >>
> >> I have tried to reset the IR remotely by resetting it via an event. (ex.
> >If
> >> reset is now true then IR Master set reset).  This isn't working.  Is
> >there
> >> a way to reset the interface without going to my ECS PC?
> >>
> >> Mark S
> >
> >--
> >Mark Gilmore
> >Omnipotence (ECS Home Automation Software)
> >omnip@usit.net
> >http://www.usit.com/omnip
> >

-- 
Mark Gilmore
Omnipotence (ECS Home Automation Software)
omnip@usit.net
http://www.usit.com/omnip

---