Subject: From: Date:

RE: [ECS] Reset interfaces remotely Mark Sekelsky Sun, 28 Feb 1999 08:22:35 -0600

---

Mark,

FWIW my model # is 100S.  In general my has been pretty reliable as well.
But as I have tried to use the mini emitters (which suddenly started
working) and use it with ACE I have had lots of little annoyances.

Mark S

> -----Original Message-----
> From: Mark Gilmore [mailto:omnip@usit.net]
> Sent: Sunday, February 28, 1999 9:48 AM
> To: ecs-list@netbloc.com
> Subject: Re: [ECS] Reset interfaces remotely
>
>
> FYI:The reason I wanted to pursue this further is that MY
> IR-Master behaves flawlessly (and has for years now).
> I would ask that any that have had such problems email
> me your model # (on the unit) and your ECS.DT. Thanks.
>
> Don wrote:
> >
> > Atta Way, Mark!
> >
> > ----- Original Message -----
> > From: Mark Sekelsky <Mark@sekelsky.com>
> > To: <ecs-list@netbloc.com>
> > Sent: Saturday, February 27, 1999 2:31 PM
> > Subject: RE: [ECS] Reset interfaces remotely
> >
> > >At this point I am going to stop worrying about the JunkMaster
> (I can still
> > >send you ecs.dt if you want it). I found that this time I
> couldn't get the
> > >interface to reset at all, even after a complete shut down and
> reboot.  I
> > >had ordered a Home Vision while my wife wasn't looking and now have it
> > fully
> > >up and running my IR, with PLC coming right behind it.
> > >
> > >Mark S
> > >
> > >-----Original Message-----
> > >From: Mark Gilmore [mailto:omnip@usit.net]
> > >Sent: Saturday, February 27, 1999 5:40 PM
> > >To: ecs-list@netbloc.com
> > >Subject: Re: [ECS] Reset interfaces remotely
> > >
> > >
> > >You can set the Item to RESET, but it won't help
> > >if a power-down on the IR-master is required.
> > >This should be reproducable without ACE.
> > >Try mimicking the same behavior with an Event.
> > >What is your "signal delay" parameter ?
> > >Please email me your ECS.DT.
> > >
> > >Mark Sekelsky wrote:
> > >>
> > >> Mark,
> > >>
> > >> In using ACE with the IR Master I find that it is pretty
> easy to create a
> > >> "not responding error."  I don't beleive this has anything to do with
> > ECS.
> > >> To correct this I need to unplug the IR Master and then go
> to the item
> > >> editor and click on the "reset" button.
> > >>
> > >> I have tried to reset the IR remotely by resetting it via an
> event. (ex.
> > >If
> > >> reset is now true then IR Master set reset).  This isn't working.  Is
> > >there
> > >> a way to reset the interface without going to my ECS PC?
> > >>
> > >> Mark S
> > >
> > >--
> > >Mark Gilmore
> > >Omnipotence (ECS Home Automation Software)
> > >omnip@usit.net
> > >http://www.usit.com/omnip
> > >
>
> --
> Mark Gilmore
> Omnipotence (ECS Home Automation Software)
> omnip@usit.net
> http://www.usit.com/omnip
>

---