Subject: From: Date:

Re: [ECS] Reset interfaces remotely Michael David Sun, 28 Feb 1999 09:57:37 -0500

---

Hi Mark!

You know - mine has too - for at least 7 years now.  I'm always surprised at
how other people have problems with theirs.

One thing I know I am doing differently than most, is that I don't use the
unit for receiving i/r signals at all, other than to learn the codes
initially.  All I do is transmit i/r signals.

Cheers!

Michael David
michael@michaeldavid.com
----- Original Message -----
From: Mark Gilmore <omnip@usit.net>
To: <ecs-list@netbloc.com>
Sent: Sunday, February 28, 1999 10:47 AM
Subject: Re: [ECS] Reset interfaces remotely


FYI:The reason I wanted to pursue this further is that MY
IR-Master behaves flawlessly (and has for years now).
I would ask that any that have had such problems email
me your model # (on the unit) and your ECS.DT. Thanks.

Don wrote:
>
> Atta Way, Mark!
>
> ----- Original Message -----
> From: Mark Sekelsky <Mark@sekelsky.com>
> To: <ecs-list@netbloc.com>
> Sent: Saturday, February 27, 1999 2:31 PM
> Subject: RE: [ECS] Reset interfaces remotely
>
> >At this point I am going to stop worrying about the JunkMaster (I can
still
> >send you ecs.dt if you want it). I found that this time I couldn't get
the
> >interface to reset at all, even after a complete shut down and reboot.  I
> >had ordered a Home Vision while my wife wasn't looking and now have it
> fully
> >up and running my IR, with PLC coming right behind it.
> >
> >Mark S
> >
> >-----Original Message-----
> >From: Mark Gilmore [mailto:omnip@usit.net]
> >Sent: Saturday, February 27, 1999 5:40 PM
> >To: ecs-list@netbloc.com
> >Subject: Re: [ECS] Reset interfaces remotely
> >
> >
> >You can set the Item to RESET, but it won't help
> >if a power-down on the IR-master is required.
> >This should be reproducable without ACE.
> >Try mimicking the same behavior with an Event.
> >What is your "signal delay" parameter ?
> >Please email me your ECS.DT.
> >
> >Mark Sekelsky wrote:
> >>
> >> Mark,
> >>
> >> In using ACE with the IR Master I find that it is pretty easy to create
a
> >> "not responding error."  I don't beleive this has anything to do with
> ECS.
> >> To correct this I need to unplug the IR Master and then go to the item
> >> editor and click on the "reset" button.
> >>
> >> I have tried to reset the IR remotely by resetting it via an event.
(ex.
> >If
> >> reset is now true then IR Master set reset).  This isn't working.  Is
> >there
> >> a way to reset the interface without going to my ECS PC?
> >>
> >> Mark S
> >
> >--
> >Mark Gilmore
> >Omnipotence (ECS Home Automation Software)
> >omnip@usit.net
> >http://www.usit.com/omnip
> >

--
Mark Gilmore
Omnipotence (ECS Home Automation Software)
omnip@usit.net
http://www.usit.com/omnip

---