Subject: From: Date:

RE: [ECS] hv/ir problems Mark Sekelsky Sat, 1 May 1999 15:31:55 -0500

---

Mark,

Inside the HV unit, right next to the IR diode is a jumper.  Make sure that
this jumper (JP) has not been disabled.

Mark S

-----Original Message-----
From: Mark Gilmore [mailto:omnip@usit.net]
Sent: Saturday, May 01, 1999 6:20 PM
To: ecs-list@netbloc.com
Subject: [ECS] hv/ir problems


Does anyone have a clue as to why my HV will
not properly reproduce ANY of my IR signals ?
This is the 1st time I have tried it.
The learning process went without a hitch.
But when I transmit (using HV OR ECS),
the IR-tx light blinks, but my equipment
shows NO sign of responding (not even their
IR-rx lights blink).
All signals are defined as:
	Pulse lengths
	Device-code = N/A
	Key code = N/A
	Transmit-enabled = CHECK
	Actions enabled = none

---