IR Master Model 100S Steven M. Eaton Wed, 23 Jun 1999 14:13:23 -0500
Wed, 23 Jun 1999 14:13:23 -0500
I have a Dancraft IR Master Model 100S. I purchased this back in Feb./Mar.
time frame. I have it working but have been experiencing where the unit will
lockup at times when ir commands are sent. Then you have to power the unit
off and back on before it will start working again with ECS. I have
relearned the ir commands that I have defined several times, tried changing
the signal delay, and changing the buffer size as well even though I am
sending only one command when it locks up. It t does this on various
commands, and not just one. I was wondering if any of you that are using the
Model 100S are experiencing any problems like this and if not, what do you
have as the model under ECS? Are there any other suggestions that I could
try to correct this problem? I have tried the model 100 and the 100X, but
experience the lockups. Any help would be greatly appreciated.
I have a Dancraft
IR Master Model 100S. I purchased this back in Feb./Mar. time frame. I have it
working but have been experiencing where the unit will lockup at times when ir
commands are sent. Then you have to power the unit off and back on before it
will start working again with ECS. I have relearned the ir commands that I have
defined several times, tried changing the signal delay, and changing the buffer
size as well even though I am sending only one command when it locks up. It t
does this on various commands, and not just one. I was wondering if any of you
that are using the Model 100S are experiencing any problems like this and if
not, what do you have as the model under ECS? Are there any other suggestions
that I could try to correct this problem? I have tried the model 100 and the
100X, but experience the lockups. Any help would be greatly appreciated.