Subject: From: Date:

Re: [ECS] Overrun error Mark Gilmore Sun, 03 Oct 1999 10:12:49 -0700

---

Mark,
I explained this problem in detail a while back.
I'll re-send it.
-- 
Mark Gilmore
Omnipotence (ECS home automation software)
http://www.usit.com/omnip
423-745-0026


Mark Sekelsky wrote:
> 
> Mark,
> 
> An old problem seems to have cropped up.  This was an issue once, but I have
> not seen it for quite a while now. I am using 4.1.012.  After ECS has been
> running for about 3 days I begin to get the following error message:
> 
> 011c O 10/03 10:14 AM:CCE3:COM3 (COMM err#2:RX overrun) (Item "Micro-Redac")
> 
> There is no rhyme or reason as to when the error occurs.  However i have
> noticed that if I use the PC for something else (it is bascially dedicated
> to ESC and ACE) the error is a little more prevalent.  But I have no way of
> recreating it.
> 
> The only way to eliminate the error is to reboot the computer.  Then all
> will be well for a few days.  the error seems to come with increasing
> frequency if I do not reboot.
> 
> The Redac is not my PLC.  All I have on it right now is one digital-input C
> item.

---