Subject: From: Date:

Re: [ECS] Overrun error Judson Gary Mull Sun, 03 Oct 1999 14:33:06 -0400

---

I am out of town, however, this appears to be the same bug I have been
trying to track down as well.  It seems to happen at random times.

      Gary


At 10:12 AM 10/03/1999 -0700, you wrote:
>Mark,
>I explained this problem in detail a while back.
>I'll re-send it.
>-- 
>Mark Gilmore
>Omnipotence (ECS home automation software)
>http://www.usit.com/omnip
>423-745-0026
>
>
>Mark Sekelsky wrote:
>> 
>> Mark,
>> 
>> An old problem seems to have cropped up.  This was an issue once, but I
have
>> not seen it for quite a while now. I am using 4.1.012.  After ECS has been
>> running for about 3 days I begin to get the following error message:
>> 
>> 011c O 10/03 10:14 AM:CCE3:COM3 (COMM err#2:RX overrun) (Item
"Micro-Redac")
>> 
>> There is no rhyme or reason as to when the error occurs.  However i have
>> noticed that if I use the PC for something else (it is bascially dedicated
>> to ESC and ACE) the error is a little more prevalent.  But I have no way of
>> recreating it.
>> 
>> The only way to eliminate the error is to reboot the computer.  Then all
>> will be well for a few days.  the error seems to come with increasing
>> frequency if I do not reboot.
>> 
>> The Redac is not my PLC.  All I have on it right now is one digital-input C
>> item.
>

---