Subject: From: Date:

[Fwd: Error Messages] Mark Gilmore Sat, 13 Nov 1999 16:41:43 -0500

Sat, 13 Nov 1999 16:41:43 -0500

---

-- 
Mark Gilmore
Omnipotence (ECS home automation software)
http://www.usit.com/omnip
423-745-0026

Subject:
From:
Date:
 Re: Error Messages
 J Gary Mull
 Sat, 13 Nov 1999 14:21:44 -0500

Mark,

How does one change the interrupt?  I went to settings and found an older
COM port that was not being used and deleted it to free Interrupt #5.  Then
I went to the resources on my multi-serial board and it will not allow me
to change the Interrupt. 

Will it be necessary to delete the multi-serial board and then reinstall it
to move it to a lower interrupt #5?

      Gary



At 02:11 PM 11/10/99 -0500, you wrote:
>Gary,
>I suspect that:
>1) These errors occur when some sort of sound is
>   being generated (probably the CLICK sound).
>2) Your sound card's IRQ is a lower number than
>   the serial-port used by your HV (making it a
>   HIGHER priority than the HV).
>3) This serial-port may have an OLD UART which does
>   not support a 16-byte FIFO (which is common to
>   most UARTs these days).
>You might try connecting the HV to COM2 or COM1.
>-- 
>Mark Gilmore
>Omnipotence (ECS home automation software)
>http://www.usit.com/omnip
>423-745-0026
>
jgary@atl.mindspring.com   Gary at Home 
jgmull@us.ibm.com          Gary at Work


 Sat, 13 Nov 1999 14:21:44 -0500