Subject: From: Date:

Re: [ECS] 14.4 Zoom Modem problems Mark Gilmore Mon, 13 Dec 1999 20:06:56 -0500

---

Scott,
Ignore the "fclass" error (this is just
ECS determining what kind of commands the
modem accepts).
-- 
Mark Gilmore
Omnipotence (ECS home automation software)
http://www.usit.com/omnip
423-745-0026


Scott Danks wrote:
> 
> Just as a thought.  Mark has been very good to work with me, but I thought I would
just mention this in case any of you have already figured out a fix for this problem.
 I have the Zoom VFP 14.4 and have it configured as the phone-interface-c item.  I setup
the system to page me when phone messages are left.  This did not work, so I setup just
a pager test.  When one of the items "Pager-test" is now on, the system just does a
"send->pager" and sends a message that this is a test page.  When the modem tries to
connect to the pager company, it gets back responses that it is dialing and connecting
at 1200.  Then it never gets a return of the "id=" string.  It did work about 2 out
of 5-6 times.  It would fail the rest of the time.  Also oddly, it gets a response that
there was an error sending "at +fclass=8".  I have run some debugs for Mark and he is
looking at them, but I thought I would save him the work if someone else has fixed this
problem already.  I reset the modem to fa!
ctory
> defaults, and set the phone-interface-c item to reset as the intial state.  Any ideas?
> 
> Scott

---