Subject: From: Date:

New to ECS Dennis Fenske Thu, 24 Feb 2000 20:49:04 -0800

---

Hello,

First, forget what I asked about the Cmax software in another message.

I am beginning to use my ECS software connected to a CPU-XA, SECU-16 and
X10 items.  I followed the Quickstart Tutorial and was able to get "My
Lamp" to function properly following the directions given.  I then
wanted to use my Powerhouse Key chain remote (model kc674) that
energizes a Powerhouse Transceiver Module (model TM751).  I wanted to
send an X10 signal and have it detected by the ECS software when the
"On" button was pressed.  This would then energize a relay on the
SECU-16.  Later when the "Off" button was pressed, the SECU-16 relay
would be de-energized.

My problem is that I cannot seem to determine how to set up the ECS
software to "detect" incoming X10 commands.

Any suggestions are welcome.

Thanks,

Dennis Fenske

---