Subject: From: Date:

Fw: DynaFace "Fault" Garry or Nancy viele Sat, 17 Jun 2000 01:58:39 -0400

Sat, 17 Jun 2000 01:58:39 -0400

---

----- Original Message ----- 
From: Garry or Nancy viele 
To: ecs lIST 
Sent: Saturday, June 17, 2000 1:50 AM
Subject: DynaFace "Fault"


I am once again trying to get back into the HA arena.  It has been a long time and I
can't find some of my documentation. I have the ecs lite (I also have the ecs dos version)
and a Dynaface interface.  However my Dynaface keeps the "Fault" light on.  does anyone
know what this means?  The communications light is constantly on and the run lite blinks.
 When I manage an X-10 light from a 4 button controller the "x-10 send/receive" light
blinks.  However the fault light stays on and the ecs program does not do anything.
 Is it the serial port?  When I disconnect the line to the computer, the communications
light goes out so I think the Dynaface is trying to do something but the computer isn't.
 Does anyone have any thoughts on where I should start to correct this problem?

P.S.  In the past I did have the system up and running (past = 4 years ago).

Thanks.

Garry Viele

---

---