Subject: From: Date:

Re: [ECS] Fw: DynaFace "Fault" Mark Gilmore Sat, 17 Jun 2000 13:49:46 -0400

---

If ECS reports no error, that means that the
REDAC is responding properly (and either "thinks"
that it is sending the commands, OR is buffering
them due to some other problem).
-- 
Mark Gilmore
Omnipotence (ECS home automation software)
http://www.usit.com/omnip
423-745-0026
Hours: Mon-Sat, 9AM-8PM/EST


Garry or Nancy viele wrote:
> 
> Mark - If the TW-523 is bad, would it blink when I use the 4 button
> controller?  In other words I have a test lamp (only one) hooked up to an
> x-10 device.  I have a 4 button controller (PLC controller) and when I dim
> or brighten the lamp the x-10 communication light on the dynaface blinks and
> so does the light on the TW-523  AND the lamp dims or brightens.  However
> none of the ECS commands have any effect at all on anything.  Since the
> TW-523 was blinking (and thus receiving signals) I wondered if that was the
> bad piece of hardware or is it the serial port in the computer not
> communicating PROPERLY with the Dynaface?  I say properly because the
> communications light on the dynaface is lighted and when I disconnect the
> telephone cable between the computer and the dynaface, the communications
> light goes out.
> 
> Any suggestions (Oh by the way, I am trying ECS Lite rather than the DOS
> version)
> 
> Thanks
> 
> Garry
> 
> ----- Original Message -----
> From: Mark Gilmore
> To: ecs-list@netbloc.com
> Sent: Saturday, June 17, 2000 7:15 AM
> Subject: Re: [ECS] Fw: DynaFace "Fault"
> 
> Hi Gary,
> If ECS is NOT reporting an error, I would suspect
> that the REDAC has a hardware failure related to
> X10 transmissions (perhaps a bad TW-523 ???).
> But I would try the current version of ECS just
> to see if it makes any diff.
> 
> BTW/FYI: I could not quote your original msg (???).
> --
> Mark Gilmore
> Omnipotence (ECS home automation software)
> http://www.usit.com/omnip
> 423-745-0026
> Hours: Mon-Sat, 9AM-8PM/EST

---