Subject: From: Date:

Re: [ECS] PLC Interface overflow? Jay Heyl Fri, 30 Jun 2000 17:06:59 -0700

---

It just occurred to me that I have a motion detector in one of the hallways
where a light is turned on by the bed time event.  It's probably the motion
detector sending out the "daylight" command.  If that's it, there's not
much I can do about it.  I use the "daylight" signal to determine if the
hallway light should be turned on when motion is detected, so I can't
disable the light sensor.  As long as ECS retries whatever didn't go
through the first time I guess it should be okay.

  -- Jay

At 18:40 06/30/00 -0400, you wrote:

>This error means that a command has been issued to
>the CM11A (by ECS) which has not been acknowledged
>after 5 seconds (i.e. it is "busy" doing "something").
>What that is I don't know (perhaps ANOTHER transmitter
>sending a burst of continuous commands ?).

---