ecsl@netbloc.com: 8063: Problem with CM11A

Subject:
From:
Date:

Problem with CM11A
Jerry Swords
Thu, 3 Aug 2000 20:01:26 -0400

Thu, 3 Aug 2000 20:01:26 -0400

I just upgraded to 4.4.005, and am having trouble with my CM11A.  When starting ECS,
and just after the "ECS at your service" message, I get the following ERROR: PLC-Interface-2H
transmit tmo0 (Item "PLC-Interface-2H).  I have tried the remedies listed in the help
section for this error, and even tried swapping out the CM11A, all with no resolution.
 I have even been getting this message occasionally throughout the day.  Has anyone
else run into this problem??

Although I have a TC+, and a CPU-XA, I prefer to use the CM11A as my PLC-interface,
because it is the only one that dims and brightens lamps in a gradual manner (as opposed
to  "step-up/step-down" changes in dim levels).  

I'd appreciate any suggestions to solve the error message problem.

Thanks,
Jerry

I just upgraded to 4.4.005, and am having trouble with my CM11A. When starting ECS, and just after the "ECS at your service" message, I get the following ERROR: PLC-Interface-2H transmit tmo0 (Item "PLC-Interface-2H). I have tried the remedies listed in the help section for this error, and even tried swapping out the CM11A, all with no resolution. I have even been getting this message occasionally throughout the day. Has anyone else run into this problem??

Although I have a TC+, and a CPU-XA, I prefer to use the CM11A as my PLC-interface, because it is the only one that dims and brightens lamps in a gradual manner (as opposed to "step-up/step-down" changes in dim levels).

I'd appreciate any suggestions to solve the error message problem.

Thanks,

Jerry