Subject: From: Date:

Re: [ECS] Problem with CM11A Scott Danks Fri, 04 Aug 2000 11:22:21 -0500

---

 Fri, 04 Aug 2000 11:22:21 -0500
I will be out of the office until 8/14/00.  I will get your message then.

Thank You,
Scott Danks

>>> "ecs-list@netbloc.com" 08/04/00 10:40 >>>

I will be out of the office until 8/14/00.  I will get your message then.

Thank You,
Scott Danks

>>> "ecs-list@netbloc.com" 08/04/00 09:53 >>>

I will be out of the office until 8/14/00.  I will get your message then.

Thank You,
Scott Danks

>>> "ecs-list@netbloc.com" 08/04/00 09:34 >>>

I will be out of the office until 8/14/00.  I will get your message then.

Thank You,
Scott Danks

>>> "ecs-list@netbloc.com" 08/04/00 08:51 >>>

Jerry,
I can't re-create any problem her, but your
not the 1st to report this problem.
Are you running Win2000 ?
-- 
Mark Gilmore
Omnipotence (ECS home automation software)
http://www.usit.com/omnip
423-745-0026
Hours: Mon-Sat, 9AM-8PM/EST


> Jerry Swords wrote:
> 
> I just upgraded to 4.4.005, and am having trouble with my CM11A.  When
> starting ECS, and just after the "ECS at your service" message, I get
> the following ERROR: PLC-Interface-2H transmit tmo0 (Item
> "PLC-Interface-2H).  I have tried the remedies listed in the help
> section for this error, and even tried swapping out the CM11A, all
> with no resolution.  I have even been getting this message
> occasionally throughout the day.  Has anyone else run into this
> problem??
> 
> Although I have a TC+, and a CPU-XA, I prefer to use the CM11A as my
> PLC-interface, because it is the only one that dims and brightens
> lamps in a gradual manner (as opposed to  "step-up/step-down" changes
> in dim levels).
> 
> I'd appreciate any suggestions to solve the error message problem.
> 
> Thanks,
> Jerry

---