Subject: From: Date:

Re: [ECS] Lynxport Mark Gilmore Wed, 30 Aug 2000 17:07:53 -0400

---

Hi Nathan,
I know of no bugs or other issues related to the Lynx.
Perhaps someone else is using it and will have a suggestion.
I would NOT perform any setup other than that documented in ECS.HTM.
Does it work with their software ?
If you have >= 3 COM ports, make sure that COM2's
IRQ does not conflict with another COM port.
-- 
Mark Gilmore
Omnipotence (ECS home automation software)
http://omnipotencesoftware.com
423-745-0026
Hours: Mon-Sat, 9AM-8PM/EST


Nathan Brown wrote:
> 
> I am trying to get ECS to talk to my Lynxport. I have it setup on COM2
> as Station #0 (indicates house code 'P' for Lynxport). Each time I
> attemp to send it a command the Lynxport light indicates an error and
> ECS states that there was "BAD DATA FROM PC". I have looked through the
> setup of the Lynxport and found several settings on handshaking and line
> termination. I found no ECS doc on what to set these to or if it
> matters. The sample schedule on the ECS web site for the Lynxport is
> blank so I don't know if I am just setting to it up wrong. Does anyone
> have any experience with this?=20
> Nathan

---