Subject: From: Date:

RE: [ECS] Lynxport Nathan Brown Wed, 30 Aug 2000 14:24:59 -0700

Wed, 30 Aug 2000 14:24:59 -0700

---

Thy LYNX seems to responds to commands from there stuff and from other
X10 sources.  I am going to write a test program to send a couple
commands through the serial line to try and diagnose the issue.  I'll
make sure to post all my results.

NB

-----Original Message----- 
From: Mark Gilmore 
Sent: Wed 8/30/2000 2:07 PM 
To: ecs-list@netbloc.com 
Cc: 
Subject: Re: [ECS] Lynxport



	Hi Nathan,
	I know of no bugs or other issues related to the Lynx.
	Perhaps someone else is using it and will have a suggestion.
	I would NOT perform any setup other than that documented in
ECS.HTM.
	Does it work with their software ?
	If you have >= 3 COM ports, make sure that COM2's
	IRQ does not conflict with another COM port.
	--
	Mark Gilmore
	Omnipotence (ECS home automation software)
	http://omnipotencesoftware.com

	423-745-0026
	Hours: Mon-Sat, 9AM-8PM/EST
	
	
	Nathan Brown wrote:
	>
	> I am trying to get ECS to talk to my Lynxport. I have it setup
on COM2
	> as Station #0 (indicates house code 'P' for Lynxport). Each
time I
	> attemp to send it a command the Lynxport light indicates an
error and
	> ECS states that there was "BAD DATA FROM PC". I have looked
through the
	> setup of the Lynxport and found several settings on
handshaking and line
	> termination. I found no ECS doc on what to set these to or if
it
	> matters. The sample schedule on the ECS web site for the
Lynxport is
	> blank so I don't know if I am just setting to it up wrong.
Does anyone
	> have any experience with this?=20
	> Nathan
	

---

["application/ms-tnef" not shown]

---