Subject: From: Date:

RE: [ECS] Ocelot IR Help Needed Joseph & Jessica Colson III Sun, 17 Sep 2000 21:36:22 -0500

---

Mark -

	Thanks for the reply.  I may have figured it out.
I was testing the setup by using the power (ON/OFF) button 
of my TV.  When I later changed to another button (Volume) it 
started working.  Hopefully this will be just a case of it didn't
like me using the power button:)

Joe Colson

-----Original Message-----
From: Mark Gilmore [mailto:omnip@usit.net]
Sent: Sunday, September 17, 2000 1:45 PM
To: ecs-list@netbloc.com
Subject: Re: [ECS] Ocelot IR Help Needed


Joe,
I don't know what would cause this, but forgetting the ECS
warning, have you tested to see if ECS will monitor the signal ?
-- 
Mark Gilmore
Omnipotence (ECS home automation software)
http://omnipotencesoftware.com
423-745-0026
Hours: Mon-Sat, 9AM-8PM/EST


Joseph & Jessica Colson III wrote:
> 
> I need some help from all of you guru's out their.
> I'm trying to setup the Infra red on the Ocelot and when
> I train a IR-Signal K type (VCR:0) it comes back with "for
> transmit only".  Now when I press the send commands it works
> fine.  So far no problem.  Now the question, how
> do I set it up so that it will monitor?  Now I read that
> it has to be within Signal #'s 1-79 which it is.  But still
> no go.  What I'm I missing.  Any help as always will be highly
> appreciated.
> 
> Thanks,
> 
> Joe Colson

---