Subject: From: Date:

RE: [ECS] X-10 communication help... A.J. Griglak Fri, 29 Sep 2000 15:03:20 -0400

---

Hmmm...  Sounds like a ADI question really.  Go to
http://www.futurestandard.com/mailinglists.htm and join the CPU-XA mailing
list.  CPU-XA is what they used to call the Ocelot.  I have an Ocelot since
December, but only used the C-MAX software for about 3 minutes.  Since then,
I've used ECS exclusively.  I'm sure if you try both, you'll come to the
same conclusion.

Good Luck

-=A.J.

-----Original Message-----
From: Stephen Weiss [mailto:seweiss@fast.net]
Sent: Friday, September 29, 2000 9:52 AM
To: ecs-list@netbloc.com
Subject: [ECS] X-10 communication help...


All,

I just received an Ocelot with a TW523 X-10 communication unit.

I have a number of in-wall controllers which I use to control X-10
in-line modules and outlets.  When I use the supplied Ocelot
software to monitor the X-10 commands and I use the in-wall
controllers to transmit a message, I don't see it in the X-10 log.
Is this typical operation?  Shouldn't I see the X-10 messages
from an in-wall controller?  I know the messages are going out
because the in-line units work fine.

Any/All help is greatly appreciated,
Stephen Weiss
seweiss@fast.net

---