Subject: From: Date:

RE: [ECS] X-10 communication help... Stephen Weiss Fri, 29 Sep 2000 15:09:26 -0400

---

A.J.

I actually did e-mail ADI, and they told me that the in-wall
transmitters transmit the extended X-10 signals that the
TW523 won't forward onto the Ocelot or any other controller.

What confuses me about this is that the in-line modules that
I have work fine, so I don't see what the extended X-10 has
to do with anything, and to me the TW523 should pick these
up.  The TW523 is supposed to be two-way, is it not?

Also, I did joing the mailing list prior to receiving your
e-mail.   Thanks for the suggestion.

I wanted to try out the C-Max software just to make sure
things were working, but I ran across this issue.  I plan
to move onto ECS, if I can (or even can't) get a worthwhile
answer to this.

Regards,
Stephen Weiss


» -----Original Message-----
» From: A.J. Griglak [mailto:aj@griglak.com]
» Sent: Friday, September 29, 2000 3:03 PM
» To: ecs-list@netbloc.com
» Subject: RE: [ECS] X-10 communication help...
»
»
» Hmmm...  Sounds like a ADI question really.  Go to
» http://www.futurestandard.com/mailinglists.htm and join the
» CPU-XA mailing
» list.  CPU-XA is what they used to call the Ocelot.  I have
» an Ocelot since
» December, but only used the C-MAX software for about 3
» minutes.  Since then,
» I've used ECS exclusively.  I'm sure if you try both, you'll
» come to the
» same conclusion.
»
» Good Luck
»
» -=A.J.
»
» -----Original Message-----
» From: Stephen Weiss [mailto:seweiss@fast.net]
» Sent: Friday, September 29, 2000 9:52 AM
» To: ecs-list@netbloc.com
» Subject: [ECS] X-10 communication help...
»
»
» All,
»
» I just received an Ocelot with a TW523 X-10 communication unit.
»
» I have a number of in-wall controllers which I use to control X-10
» in-line modules and outlets.  When I use the supplied Ocelot
» software to monitor the X-10 commands and I use the in-wall
» controllers to transmit a message, I don't see it in the X-10 log.
» Is this typical operation?  Shouldn't I see the X-10 messages
» from an in-wall controller?  I know the messages are going out
» because the in-line units work fine.
»
» Any/All help is greatly appreciated,
» Stephen Weiss
» seweiss@fast.net
»

---