Subject: From: Date:

Re: [ECS] Creating ECS interface to my Access Control System Bill Walters Mon, 23 Oct 2000 23:38:26 -0500

---

Dario,
   OK, OK, OK....  I got smart enough to figure out "INGLEIS" was english;
still, would like more access?

Bill

----- Original Message -----
From: "Bill Walters" <wtwalters@earthlink.net>
To: <ecs-list@netbloc.com>
Sent: Monday, October 23, 2000 11:23 PM
Subject: Re: [ECS] Creating ECS interface to my Access Control System


> Dario,
>
> Took a look at your web page in your signature.....  My Italian is
> nonexistant; any chance for english translations?
>
> (<very big grin!!>)
>
> Bill Walters
>
>
>
> ----- Original Message -----
> From: "Dario Greggio" <adpm.to@inwind.it>
> To: <ecs-list@netbloc.com>
> Sent: Monday, October 23, 2000 3:07 PM
> Subject: Re: [ECS] Creating ECS interface to my Access Control System
>
>
> > Brian McGinnis wrote:
> > >
> > > I just purchased some "Hot Little Therms" which are temp sensors built
> > > around the Dallas chip.
> > >
> > > They use a serial protocol to communicate with the unit.
> > >
> > > So... I ended up writing a little utility program to sample the therms
> on a
> > > user defined interval, do the conversion, and then pass the state
values
> > > directly to ECS via a DDE link.  This seems to work very well.  I
> created a
> > > new custom item type that contains all of the possible values from
> > > around -50 to +140 degrees (which, when converting from celsius, not
all
> > > tenths values are used.)
> >
> > Hi Brian. I know the Dallas chips. I was going to use them but I haven't
> > yet. Could you make available the source code for your utility? If it's
> > not a problem to you, it may save me time when I decide to work with
> > them.
> > Thanks!
> >
> > --
> > Ciao,
> > Dario
> > --
> > ADPM Synthesis sas - Torino
> > --
> > http://www.geocities.com/adpm99
> >
> >
> >
>
>

---