Subject: From: Date:

From prototype test bed to real life testing. Dennis Fenske Mon, 27 Nov 2000 19:33:57 -0800

---

Hello to everyone.

With Mark Gilmore's help, I have been able to get my ecs and ocelot working in test
bed mode, but when
moved..............

The ECS program seemed to be working well with everything set up in one room.  I moved
it to the real situation
where the equipment is 40 actual feet from one of the X10 motion sensors.  However,
the electrical path is
probably 120 feet.  That sensor's X10 code is not picked up by the Ocelot.  However,
I have an appliance module
within 3 feet on the same circuit that does pick up the sensor's code.  Any suggestions?

Thanks,

Dennis Fenske

---