Subject: From: Date:

Re: [ECS] From prototype test bed to real life testing. Bill Walters Mon, 27 Nov 2000 22:58:31 -0600

---

Yep, your two outlets may be on different phases of your AC service.  You
may need a signal bridge.

Bill Walters

----- Original Message -----
From: "Dennis Fenske" <dcfenske@ix.netcom.com>
To: <ecs-list@netbloc.com>
Sent: Monday, November 27, 2000 9:33 PM
Subject: [ECS] From prototype test bed to real life testing.


> Hello to everyone.
>
> With Mark Gilmore's help, I have been able to get my ecs and ocelot
working in test bed mode, but when
> moved..............
>
> The ECS program seemed to be working well with everything set up in one
room.  I moved it to the real situation
> where the equipment is 40 actual feet from one of the X10 motion sensors.
However, the electrical path is
> probably 120 feet.  That sensor's X10 code is not picked up by the Ocelot.
However, I have an appliance module
> within 3 feet on the same circuit that does pick up the sensor's code.
Any suggestions?
>
> Thanks,
>
> Dennis Fenske
>
>

---